Open Access Journal
ISSN : 2394 - 6849 (Online)
International Journal of Engineering Research in Electronics and Communication Engineering(IJERECE)
Open Access Journal
International Journal of Engineering Research in Electronics and Communication Engineering(IJERECE)
ISSN : 2394-6849 (Online)
Reference :
[1] T Masuzawa, “State of the Art of Micromachining”, Institute of Industrial Science, University of Tokyo, Tokyo, Japan. Annals of the ClRP Vol.49., 2000.
[2] Muhammad Pervej Jahan & T. W. Lieh &Yoke San Wong & Mustafizur Rahman, “An experimental investigation into the micro-electro discharge machining behavior of p-type silicon”, The international journal of Advanced Manufacturing Technology, (2011) 57:617– 637.
[3] Dominick Reynaerts , Wim Meeusen, Hendrik Van Brussel, “Machining of three-dimensional microstructures in silicon by electro discharge machining”, Sensors and Actuators A 67 ( 1998) 159-165.
[4] LI Mao-sheng , CHI Guan-xin, WANG Zh enlong, WANG Yu-kui, DAI Li, “Micro electrical discharge machining of small hole in TC4 alloy”, Transactions of Non Ferrous Metals of China 19(2009)s434-s439, 2009.
[5] S. Mahendran, R. Devarajan, T. Nagarajan, and A. Majdi, “A Review of Micro-EDM”, International multi conference of Engineers and computer scientists, march 2010
[6] Aruna K. Somashekar S H, “Investigation on performance parameters of Micro Electrical Discharge Machining”, Thesis Department of Mechanical Engineering, IIT Madras, Chennai.
[7] Kun Liu & Bert Lauwers & Dominiek Reynaerts, “Process capabilities of Micro-EDM and its applications”, The international journal of Advanced Manufacturing Technology, (2012) s00170-009-2056-1.
[8] M.L. Chan, P. Fonda, C. Reyes, J. Xie , H. Najar, L. Lin, K. Yamazaki1 and D.A. Horsley, “Micromachining 3D Hemispherical Features In Silicon Via Micro-Edm”, IEEE 978-1-4673-0325-5/12/$31.00 ©2012